Effectiveness of post-fire salvage logging stream buffer management for hillslope erosion in the U.S. Inland Northwest Mountains

Active wildfire seasons in the western U.S. warrant the evaluation of post-fire forest management strategies. Ground-based salvage logging is often used to recover economic loss of burned timber. In unburned forests, ground-based logging often follows best management practices by leaving undisturbed areas near streams called stream buffers. However, the effectiveness of these buffers has not been tested in a post-wildfire setting. This experiment tested buffer width effectiveness with a novel field-simulated rill experiment using sediment-laden runoff (25 g/L) released over 40 min at evenly timed flow rates (50, 100 and 150 L/min) to measure surface runoff travel length and sediment concentration under unburned and high and low soil burn severity conditions at 2-, 10- and 22-month post-fire. High severity areas 2-month post-fire had rill lengths of up to 100 m. Rill length significantly decreased over time as vegetation regrowth provided ground cover. Sediment concentration and sediment dropout rate also varied significantly by soil burn severity. Sediment concentrations were 19 g/L for the highest flow 2-month post-fire and reduced to 6.9–14 g/L 10-month post-fire due to abundant vegetation recovery. The amount of sediment dropping out of the flow consistently increased over the study period with the low burn severity rate of 1.15 g L⁻¹ m⁻¹ approaching the unburned rate of 1.29 g L⁻¹ m⁻¹ by 2-year post-fire. These results suggest that an often-used standard, 15 m buffer, was sufficient to contain surface runoff and reduce sediment concentration on unburned sites, however buffers on high burn severity sites need to be eight times greater (120 m) immediately after wildfire and four times greater (60 m) 1-year post-fire. Low burn severity areas 1-year post-fire may need to be only twice the width of an unburned buffer (30 m), and 2-year post-fire these could return to unburned widths.     

Analysis of soil drying incorporating a constitutive model for curling

This paper focuses on the shrinkage behavior of soil specimens involving sand, kaolinite, and kaolinite/sand mixtures subjected to desiccation under controlled conditions. Both, free and restrained shrinkage conditions are studied. The experiments show that pure soils do not curl upon unrestrained shrinkage; however, (under the same conditions) kaolinite/sand mixtures exhibited a marked curling. Furthermore, the mixture with the higher sand content broke through the middle of the sample after displaying a significant curling. Soils subjected to restricted shrinkage developed cracks with slight curling. To simulate the observed behavior, a mechanical model able to reproduce the detachment of the soil sample from the mold is proposed in this work and implemented in a fully coupled hydro-mechanical finite-element code. It is concluded that suction and differential shrinkage are key factors influencing the curling behavior of soils. The proposed framework was able to satisfactorily explain and reproduce the different stages and features of soil behavior observed in the experiments.

     

William Smith's map brought alive by digital remastering

The geological mapping carried out by William Smith, which resulted in the publication of his famous map in 1815, was remarkable in many respects, not least because it relied on him being able to make consistent and accurate observations on the rock types he encountered during his fieldwork. This ability, gained from his many years studying rocks, allowed him to observe features with his own eyes (or at the very least, with the aid of a simple magnifying device) that others could not. We take a new look at William Smith's original stratigraphical sequences, and with samples collected from his classic field areas (many of which are around the city of Bath, Somerset, UK), demonstrate how spatial mineralogy mapping can be incorporated into the modern age of digital mapping.     

Adding the missing third and fourth dimensions to trajectory analysis in carbonate systems

We developed a seismic geomorphology-based procedure to enhance traditional trajectory analysis with the ability to visualize and quantify lateral variability along carbonate prograding-margin types (ramps and rimmed shelves) in 3D and 4D. This quantitative approach analysed the shelf break geometric evolution of the Oligo-Miocene carbonate clinoform system in the Browse Basin and delineated the feedback between antecedent topography and carbonate system response as controlling factor on shelf break rugosity. Our geometrical analysis identified a systematic shift in the large-scale average shelf break strike direction over a transect of 10 km from 62° to 55° in the Oligo-Miocene interval of the Browse Basin, which is likely controlled by far-field allogenic forcing from the Timor Trough collision zone. Plotting of 3D shelf break trajectories represents a convenient way to visualize the lateral variability in shelf break evolution. Shelf break trajectories that indicate contemporaneous along-strike progradation and retrogradation correlate with phases of autogenic slope system re-organization and may be a proxy for morphological stability of the shelf break. Shelf break rugosity and shelf break trajectory rugosity are not inherited parameters and antecedent topography does not dictate long-term differential movement of the shelf margin through successive depositional sequences. The autogenic carbonate system response to antecedent topography smooths high-rugosity areas by filling accommodation and maintains a relatively constant shelf break rugosity of ~150 m. Color-coding of the vertical component in the shelf break trajectory captures the creation and filling of accommodation, and highlights areas of the transect that are likely to yield inconsistent 2D sequence stratigraphic interpretations.     

The timing of salt structure growth in the Southern Permian Basin (Central Europe) and implications for basin dynamics

In this paper, a literature‐based compilation of the timing and history of salt tectonics in the Southern Permian Basin (Central Europe) is presented. The tectono‐stratigraphic evolution of the Southern Permian Basin is influenced by salt movement and the structural development of various types of salt structures. The compilation presented here was used to characterize the following syndepositional growth stages of the salt structures: (a) “phase of initiation”; (b) phase of fastest growth (“main activity”); and (c) phase of burial’. We have also mapped the spatial pattern of potential mechanisms that triggered the initiation of salt structures over the area studied and summarized them for distinct regions (sub‐basins, platforms, etc.). The data base compiled and the set of maps produced from it provide a detailed overview of the spatial and temporal distribution of salt tectonic activity enabling the correlation of tectonic phases between specific regions of the entire Southern Permian Basin. Accordingly, salt movements were initiated in deeply subsided graben structures and fault zones during the Early and Middle Triassic. In these areas, salt structures reached their phase of main activity already during the Late Triassic or the Jurassic and were mostly buried during the Early Cretaceous. Salt structures in less subsided sub‐basins and platform regions of the Southern Permian Basin mostly started to grow during the Late Triassic. The subsequent phase of main activity of these salt structures took place from the Late Cretaceous to the Cenozoic. The analysis of the trigger mechanisms revealed that most salt structures were initiated by large‐offset normal faults in the sub‐salt basement in the large graben structures and minor normal faulting associated with thin‐skinned extension in the less subsided basin parts.     

Strain analysis of a seismically imaged mass‐transport complex,offshore Uruguay

Strain style, magnitude and distribution within mass‐transport complexes (MTCs) are important for understanding the process evolution of submarine mass flows and for estimating their runout distances. Structural restoration and quantification of strain in gravitationally driven passive margins have been shown to approximately balance between updip extensional and downdip contractional domains; such an exercise has not yet been attempted for MTCs. We here interpret and structurally restore a shallowly buried (c. 1,500 mbsf) and well‐imaged MTC, offshore Uruguay using a high‐resolution (12.5 m vertical and 15 × 12.5 m horizontal resolution) three‐dimensional seismic‐reflection survey. This allows us to characterise and quantify vertical and lateral strain distribution within the deposit. Detailed seismic mapping and attribute analysis shows that the MTC is characterised by a complicated array of kinematic indicators, which vary spatially in style and concentration. Seismic‐attribute extractions reveal several previously undocumented fabrics preserved in the MTC, including internal shearing in the form of sub‐orthogonal shear zones, and fold‐thrust systems within the basal shear zone beneath rafted‐blocks. These features suggest multiple transport directions and phases of flow during emplacement. The MTC is characterised by a broadly tripartite strain distribution, with extensional (e.g. normal faults), translational and contractional (e.g. folds and thrusts) domains, along with a radial frontally emergent zone. We also show how strain is preferentially concentrated around intra‐MTC rafted‐blocks due to their kinematic interactions with the underlying basal shear zone. Overall, and even when volume loss within the frontally emergent zone is included, a strain difference between extension (1.6–1.9 km) and contraction (6.7–7.3 km) is calculated. We attribute this to a combination of distributed, sub‐seismic, ‘cryptic’ strain, likely related to de‐watering, grain‐scale deformation and related changes in bulk sediment volume. This work has implications for assessing MTCs strain distribution and provides a practical approach for evaluating structural interpretations within such deposits.     

Clitellate worms (Annelida) in lateglacial and Holocene sedimentary DNA records from the Polar Urals and northern Norway

While there are extensive macro‐ and microfossil records of a range of plants and animals from the Quaternary, earthworms and their close relatives amongst annelids are not preserved as fossils and therefore the knowledge of their past distributions is limited. This lack of fossils means that clitellate worms (Annelida) are currently underused in palaeoecological research, even though they can provide valuable information about terrestrial and aquatic environmental conditions. Their DNA might be preserved in sediments, which offers an alternative method for detection. Here we analyse lacustrine sediments from lakes in the Polar Urals, Arctic Russia, covering the period 24 000–1300 cal. a BP, and NE Norway, covering 10 700–3300 cal. a BP, using a universal mammal 16S rDNA marker. While mammals were recorded using the marker (reindeer was detected twice in the Polar Urals core at 23 000 and 14 000 cal. a BP, and four times in the Norwegian core at 11 000 cal. a BP and between 3600–3300 cal. a BP), worm extracellular DNA ‘bycatch’ was rather high. In this paper we present the first reported worm detection from ancient DNA. Our results demonstrate that both aquatic and terrestrial clitellates can be identified in late‐Quaternary lacustrine sediments, and the ecological information retrievable from this group warrants further research with a more targeted approach.     

Flexural deformation controls on Late Quaternary sediment dispersal in the Garo-Rajmahal Gap,NW Bengal Basin

Subsurface deformation is a driver for river path selection when deformation rates become comparable to the autogenic mobility rate of rivers. Here we combine geomorphology, soil and sediment facies analyses, and geophysical data of the Late Quaternary sediments of the central Garo-Rajmahal Gap in Northwest Bengal to link subsurface deformation with surface processes. We show variable sedimentation characteristics, from slow rates (<0.8 mm/year) in the Tista megafan at the foot of the Himalaya to nondeposition at the exposed surface of the Barind Tract to the south, enabling the development of mature soils. Combined subsidence in the Tista fan and uplift of the Barind Tract are consistent with a N-S flexural response of the Indian plate to loading of the Himalaya Mountains given a low value of elastic thickness (15–25 km). Provenance analysis based on bulk strontium concentration suggests a dispersal of sediment consistent with this flexural deformation—in particular the abandonment of the Barind Tract by a Pleistocene Brahmaputra River and the current extents of the Tista megafan lobes. Overall, these results highlight the control by deeply rooted deformation patterns on the routing of sediment by large rivers in foreland settings.     

Relational Agriculture: Gender,Sexuality, and Sustainability in U.S. Farming

Although 97% of U.S. farms are “family-owned,” little research examines how gender and sexual relationships – inherent in familial dynamics – influence farmers’ practices and livelihoods. Gender and sexual dynamics – shaped by race and class – affect who is considered a farmer, land management decisions, and access to resources like land, subsidies, and knowledge. We use feminist and queer lenses to illuminate how today’s agricultural gender and sexual relations are not “natural,” but when left uninterrogated are constructed in ways that harm women and queer farmers while limiting potential to develop sustainable practices. Women and queer farmers also resist, “re-orienting” gender and sexual relations in ways that expand possibilities for achieving food justice and ecological sustainability. We offer “relational agriculture” as a tool for making visible and re-orienting gender and sexual relations on farms. Relational agriculture brings sexuality into food justice and demonstrates the centrality of gender and sexuality to agricultural sustainability.